S-74S STANDARD W/F

S Models (Basic 70 Series feeders):

• Wire speed control.
• Factory-set run-in control for improved arc starts.
• 24 VDC high-torque, permanent-magnet motor.
• Quick-release, drive-roll pressure adjustment arm allows drive roll change without losing spring preload setting.
• Solid-state speed control and brake circuit for increased service life.
• Floating positive drive systems provide trouble-free feeding on a variety of wires.

D Models Add the Following Features:

• Digital meters for easy viewing of the wire feed speed and Voltage.
• Remote Voltage control allows operator to set Voltage at the wire feeder without having to go back to the power source.
• Tachometer feedback to help keep wire feed speed accurate.

DX Models add the Following Features:

• Four weld programs allow the operators to store four independent welding parameters reducing welding setup time (four programs available per side on dual feeder).
• Adjustable run-in control for improved arc starts.
• Adjustable weld sequence control gives operator complete control of the welding parameters: pre-flow, run-in, weld time, crater, burn-back and post-flow.
• Welding process range control locks parameters at a set percentage of welding parameters to ensure welding procedures and quality standards are maintained on the shop floor.
• Dual schedule allows operator to switch between two welding parameters without readjusting the machine, eliminating downtime and enhancing quality.

Specifications:

• Welding Mode: CV/DC
• Input Power: 24 VAC, 10 A, / 50/60 Hz
• Wire Speed: 1.3 – 19.8m/min
• Electrode Wire Diameter Capacity: Solid Wire: 0.9 – 1.6 mm / Flux Cored:1.2 – 2.8 mm

Dimensions (mm):

• S-74 Single: H: 356 / W: 318 / D: 711 
• D-74 Dual: H: 356/ W: 533 / D: 889

Weight:

• S-74 Single: 26 kg
• D-74 Dual: 39.5 kg